MAGNET SENSOR

Monitor doors and/or windows, sends you sms,mail and push notifications when system are armed. Picks up temperature which can be used to control heating. 

  • Magnetic sensor - IAS zone

  • Temperature sensor

    • supported logics:

      • Security(std), 

      • Climate control(std)

      • Generic(not in use atm)

How to Install/Pair a magnet sensor

  • Open the casing of the device. 

  • Start the search in the app

  • Plant the enclosed batteries into the device and close the casing. 

    • not showing up in search? 

      • Start search in app

      • Follow the reset routine

How to configure a magnet sensor

  • Click configure on the motion sensor after scanning for new devices

  • Add a device name

  • Add the device to a room

    • Select the room you want from the list or add a new room

  • Enter details for security sensor

    • Add the application: Security

    • Select the usage options, one or more: 

      • Away

      • Stay

      • Night

  • Enter details for temperature sensor

    • Add the application: Climate control

    • Usage option: 

      • Heating device

      • Cooling device

Resetting is needed it you want to connect your sensor to another gateway or if you need to perform a factory reset to remove abnormal behavior.

1. Press and hold down the reset button for approximately 10-15 seconds. 

2. When the red light starts flashing continuously, the reset process has been successfully implemented and you can release the button. 

Faults/Modes:

Red light

  • Flashing every second for a longer period, means that the device is searching for the gateway

  • Three flashes means that the device has failed to connect to the gateway. 

Green light

  • A single flash means that the sensor and the magnet are moving either towards each other or away from each other.