THE METER READER

Meter interface for power, gas, water & heat meters. 

  •  LED/IR sensor

  •  P1 interface

  •  Pulse interface

  •  S0 interface

    • supported logics:

      • Generic

How to Install/Pair a Meter Reader

  1. Open the casing of the device. 

  2. Start the search in the app

  3. Plant the enclosed batteries into the device and close the casing. 

    • not showing up in search? 

      • Start search in app

      • Follow the reset routine

How to configure a Meter Reader

  • Click configure on the meter reader after scanning for new devices

  • Add a device name

  • Add the device to a room

    • Select the room you want from the list or add a new room

  • Enter details for combined interface:

    • Add the application: generic(default)

Resetting is needed if you want to reconnect your External Meter Interface or if you need to perform a factory reset to remove abnormal behaviour.

1. Open the casing of the device. 

2. Press and hold the menu button until the LED flashes continuously then release the button again. 

3. After a successful reset the green LED will start flashing which indicates network search. 

Faults/Modes:

  • If the External Meter Interface does not send correct meter data, validate that the probe is mounted correctly to the meter. 

  • In case of a weak or a bad signal, change the location of the External Meter Interface or strengthen the signal with a smart plug.