SMART PLUG MINI

The Smart Plug Mini allows you to instantly turn on and off any device from across the world - or from the living room.

  • Accurate power consumption measurement

  • Remote on/off control

    • supported logics: 

      • climate control 

      • light

      • generic

How to Install/Pair a Smart Plug Mini

  • Connect the Smart Plug Mini to the power outlet. 

  • The Smart Plug Mini will now start searching (up to 15 minutes) for a ZigBee network to join.

  • Make sure that the ZigBee network is open for joining devices and will accept the Smart Plug Mini. 

  • While the Smart Plug Mini is searching for the network, the LED button is flashing red.

  • When the LED button stops flashing, the Smart Plug Mini has successfully joined the ZigBee network.

How to configure a Smart Plug Mini

  • Click configure on the Smart Plug Mini after scanning for new devices

  • Add a device name

  • Add the device to a room

    • Select the room you want from the list or add a new room

  • Enter details for: Smart plug

    • Add the application: Climate control, light or generic

    • If Climate control are selected choose usage option: 

      • Heating device

      • Cooling device

Resetting Resetting is needed if you want to connect your Smart Plug Mini to another gateway, if you need to perform a factory reset to remove abnormal behaviour, or if you need to reset accumulative registers and logs.

STEPS FOR RESETTING 

1. Connect the Smart Plug Mini to the power outlet. 

2. Press and hold down the button on the device. 

3. Hold the button down until the red LED flashes continuously, then release the button.

4. After releasing the button, the red LED will stay on for 2-5 seconds. During that time, the device must not be switched off or unplugged

Faults/Modes:

SEARCHING GATEWAY MODE A red LED is flashing every second

NORMAL MODE Green LED means that the Smart Plug output is active (relay is on). The relay can be switched on and off by pushing the LED button. 

OFF MODE When there is no light in the LED button, it means that the relay is off (there is no output). The relay can be switched on and off by pushing the LED button.

  • In case of power failure, the device will restore itself to the on/off status it had before the power failure.

  • In case of a bad or weak signal, change the location of the Smart Plug Mini or your gateway.

  • If the search for a gateway has timed out, a short press on the LED button will restart it.